HT1800-220-M (220-240V)

▸ PRODUCTS ▸ CARPET ▸ ACCESSORIES AND SPECIAL DEVICES

Instant heater that can be connected to Santoemma machines to instantly heat the water used for cleaning.

To perfectly clean and sanitize carpets and fabrics!

Power
1800 W

Voltage
220-240V

Cable lenght
40 cm

Specific tests show that cleaning carpet with just 10°C more can give the same result as cleaning twice. With HT1800 a much better result is obtained in cleaning even very dirty carpets and textiles.

The thermal protections of HT1800 limit the maximum temperature to 65-70°C in order not to damage the textiles. These temperatures allow you to effectively clean and sanitize carpets and fabrics.

The use of hot water also reduces the drying time and is appreciated for working in winter and in cold areas.

Optional for:

CARPET models: Sabrina-Maxi, Serena-Silent, Grace-Silent, Charis-ONE, Charis-DUAL, Elite-Silent, Powerful-Silent
UPHOLSTERY models: Sabrina-Maxi, Serena-Silent, Grace-Silent
CAR Wash models: SW30, SW50, SW70

HT1800-220-M is equipped with a 40cm power cable for connection to the socket on the machine body (only for 230V versions). The machine and heater are then powered through the machine's only electrical cable.

It is necessary to verify that the electrical system can provide the total power through a single socket. If not, it is possible to choose the model HT1800-220-HP, equipped with an independent power cable.

Santoemma instant heating system allows to get hot water immediately after switching the machine on. It is not necessary to wait a long time before the whole solution tank gets warm.
Its modular design allows an easy connection to the machines.
The boiler has a double protection to avoid overheating. It is also protected against dry working. The status of the 2 thermal protection is shown by 2 lights.
It is possible to achieve higher temperatures by letting the water re-circulating into the solution tank for some minutes.

Voltage:			220-240V 50-60HZ (other voltages are available upon request)
Power:			1800W
Cable lenght:			40cm
Dimensions:			11 x 16 x 34 cm
Weight:			6,5 kg
TEMPERATURE INCREASE (Delta T) WITH RESPECT TO THE INPUT TEMPERATURE Water temperature increases when using nozzles with smaller sections.
Tool used	Delta T with continuous flow	Delta T with typical used (brief intervals without spraying )
NS10PN-M	~ +32°C	~ +43°C
NS270N-M	~ +29°C	~ +39 °C
NS300-M	~ +12°C	~ +16°C
It is possible to pre-heat the water, in order to obtain higher temperatures. The thermal protections limit the maximum temperature at 65°-70°C.